WARNING:
・ALWAYS remove the fuel canister before stowing the stove.
・NEVER stow the stove with the fuel canister installed. If the
stove is installed onto the canister and it is dropped or impacted,
a gas leak or fire may result.
CAUTION:
Beware of gas leaks while installing the canister to the stove.
If you detect a gas leak by smell or sound, the stove is not properly
installed. Uninstall the stove from the canister and reinstall it again.
If the leak is still detected, send the stove back to store where
purchased or to SOTO for further inspection.
Setting the burner:
Turn the reflective sheet upward as shown in the illustration. Spread
open the 4 pot supports until they are in the locked position.
Confirm that each pot support is firmly locked and secured.
Adjusting the output:
Turn the flame control knob to adjust the flame. CAREFULLY avoid
touching the pot support during this procedure. Touching the pot
support during use may cause burns.
Confirm that the guide on the canister holder is at the correct position
(turned all the way to the left). Push fuel canister against the guide
section, then turn fuel canister according to the direction.
Operating instructions
Stowing the stove:
Make sure that the stove is completely cooled before stowing the
product. The pot support must be closed by lifting slightly upwards
and turning downwards under the burner head. Place the stove into
the carrying case.
Turn the flame control knob to the left (counterclockwise)
approximately 1.5 times. Push the Stealth Igniter to light the stove.
If the stove does not light immediately, turn the flame control knob
to the OFF position and repeat the process. If the stove does not
ignite due to natural conditions such as strong winds,
temperature, or moisture in the air, use a match or
lighter to ignite the stove
Flame control knob
Igniter push button
＊Canister sold separately.
Pot support
Burner
CAUTION for burning:
Never touch the pot support while stove is in use.
Wait until it has cooled off after use.
Failure to follow this instruction may cause
severe burning.
Installation of the canister:
Igniting the Stove:
WARNINGS:
・Beware of raw gas! DO NOT ignite when a raw gas leak is
detected. Turn the flame control knob to the OFF position and
repeat the lighting procedure.
・Never move the stove while in use. Failure to follow this
instruction may cause the flame to suddenly leap due to a raw
gas leak. This may result in burns or an accidental fire. NEVER
carry or move the stove while it is in use.
Part Names/Specifications
Electrode
Canister holder
Reflective sheet
Product name: Regulator Stove
Model: ST-310
Dimensions when in use:16.6x14.2x11.0 cm (6.6x5.7x4.4 inch)
Dimensions when stowed: 14.0x7.0x11.0 cm (5.6x2.8x4.4 inch)
Weight: 350 g (12.2 oz.)
Ignition: Stealth Igniter installed
Type of fuel: LPG/Butane
Gas consumption: 120g/h
OFF
Guide
Cut
Guide
Guide
Reflective sheet
Lock the pot support.
ON
Extinguishing the Flame:
Turn the flame control knob fully to the right (clockwise) to the OFF
position.
Pot supports
are hot!
Removing the fuel canister:
Turn the fuel canister counter-clockwise 60 to remove canister from
the stove.
Caution!
To Previous Page
Loading...