31
MAINTENANCE
STEP 1
Place the lens housing onto the pressure housing ensuring
the pin engages into the hole in the focus bracket. Connect
the top two Screws on the front of the Explorer and the
bottom two Screws on the back of the Explorer.
Note: Do not overtighten Screws. See Page 2 for approved
torque values.
STEP 2
Power the sonar, and connect it to ARIScope. While
looking through the silt plug holes, move the focus by
sliding the range slider in ARIScope back and forth.
Note: If engaged properly, you will see the focus lens
moving back and forth through the silt plug holes.
ASSEMBLY
To Next Page
Loading...