Using the Parrotplus
These instructions apply to both the Parrotplus and Parrotplus2. Where
differences occur these will be referred to in the text.
Ensure that the switch on the rear of the speaker is in the OFF position.
Connect the handset to the speaker using the lead provided, and turn the
Parrotplus ‘ON’ using the switch.
The graphical display should light up and the Parrotplus will run a self test
as shown below.
And this should be immediately followed by the Serial number and
firmware revision display screen.
This screen remains visible for a short time, the unit will then display the
menu for selecting a test group.
To Next Page
Loading...