Need help?Do you have a question about the SoundFlow SoundBoard and is the answer not in the manual?
General| Brand | SoundFlow |
|---|---|
| Model | SoundBoard |
| Bluetooth Version | 5.0 |
| Output Power | 10W |
| Category | Portable Speaker |
| Connectivity | Bluetooth |
| Frequency Response | 20kHz |
Power your Soundboard using either 3 AA batteries or the USB power cable.
Choose a song with consistent volume to find the best spot for your phone.
Set phone volume around 50% as a starting point for best results.
Press the power button on the side; it illuminates when on.
Line up phone speaker with the bottom bar; audio plays within seconds.
Center side speakers over the bottom bar if your phone's speaker is on the edge.
Listen for louder openings with grills to locate your phone's speaker.
Remove phone case if it covers speakers, as it may hinder sound detection.
Experiment with phone positions to find the optimal placement for sound.
Use VOLUME + and - buttons on the side; it beeps at max/min volumes.
Connect audio devices using the stereo mini-jack cable to the AUX jack.
Place phone on Soundboard, enable speakerphone mode during calls.
Addresses issues like intermittent sound, distorted audio, or no sound.
Resolves cracking/popping noises or hum when phone is placed on Soundboard.
To Next Page