DISC4020 / English Manual
ENG 4
z Repeat/Random mode
Press the “ Play Mode ” button (18) during playback to select repeat and random function, a single track, all the tracks repeat or
folder repeat(MP3 only) and random can be played in difference mode as follow:-
For CD
(1) repeat 1 (2) repeat all track (3) random (4) off mode
Indicator
Play mode on LCD display
Repeat track
& flashing
Repeat all
Random RAN
Off mode --------------
For MP3 Disc
(1) repeat 1
(2) repeat all tracks (3) repeat 1 folder
(5) off mode (4) random
Indicator
Play mode on LCD display
Repeat single track
& flashing
repeat all tracks
Repeat single folder
Random mode RAN
Off mode
z Repeat play
You can listen the desired track or whole disc repeat by this function.
z Random play
You can listen all the tracks in a random order by this function.
CD programming
Up to 20 tracks can be programmed for disc play in any order. Before use, be sure to press the “ stop ” button (9).
1. Set in CD mode & stop the CD playback.
2. Press the “ Mem/Clk-Adj ” button (17) and “ MEM ” will appear on LCD display (1).
3. Select a desired track by pressing skip up
or down button (16).
4. Press the “ Mem/Clk-Adj ” button (17) to store the track into memory.
5. Repeat steps 3 and 4 to enter additional tracks into the memory if necessary.
6. When all the desired tracks have been programmed, press “ Play/Pause
” button (10) to play the disc in assigned order.
7. Press “ Stop
” button (9) to stop playback, press Stop button again to clear all stored memory.
¾ The programming mode will automatically stop if no button is being pressed in a period of about 10 seconds after pressing
the “Mem/Clk-Adj ” button.
To Next Page
Loading...
