Sovereign M4E1232C - Blade Maintenance

24
Maintenance
Wipe the equipment with a soft brush or blow it with
compressed air at low pressure after usage.
• Clean the mower regularly with a soft brush. Do not use
cleaning agents or solvents; these may damage
plastic components.
• Ensure that no water can seep into the device.
22
23
IMPORTANT! Always wear safety gloves when engaging
in any maintenance work. Only replace the blade with
a suitable replacement blade, as this will ensure top
performance and safety under all conditions.
Blade Maintenance
If the blade is blunt, it can be sharpened in a specialised
workshop. If the blade is damaged or showing signs of
imbalance, it must be replaced.
Carry out the following steps to change the blade:
• Turn the mower over and rest it carefully on its side.
• Use safety gloves and hold the blade rmly. Turn the
blade nut anticlockwise to remove the blade
(Fig. 17).
• Install the new blade in the reverse order. Ensure that the
blade is positioned correctly and the screw
tightened rmly.
22