08
Install Accelerometer X PartAssembly
1
Remove the M3 screw on the left side of the mounting plate
2
Mount the accelerometer using a M3X12 screws as shown.
Please note that the direction of the acceleration should not be reversed.
Refer to the direction indicated by the XY coordinate axis as shown.
The accelerometer should be installed squarely, flush with the sides
of the nozzle, not skewed.
To measure the X-axis acceleration, the following is the installation position of the accelerometer.
The accelerometer is an optional module, you can choose whether to install it
according to your needs.
Y
X
To Next Page