EMS
RF
BEFORE FIRST USE
Quick Start
Guide
USB Charging
Port
Control Panel
with 4 Combination Modes
(see pg 4)
Dual Treatment
Head
LORI is cordless and rechargeable.
Before use, fully charge for 4 hours, even if
the indicator lights turn green sooner than
4 hours.
CHARGING
To access the USB charging port, open the
waterproof seal cover located at the base
of the handle. Connect the USB end of the
provided charging cord to a USB port of a
computer, or a USB wall adapter, and plug
into an electrical outlet. As the LORI charges
all the lights on its control panel will be red
(gure a.) The indicator light will turn green
when the device is fully charged.
Recharge the LORI only as needed and up
to 4 hours only. DO NOT overcharge which
can shorten the battery life. Disconnect the
charging cord when not charging the device.
LORI should be powered OFF and cannot
be used while charging.
POWERING OFF AND ON
Long Press the power button to turn
the device ON/OFF. LORI will shut off
automatically after about 10 minutes of
continuous use.
CYCLING THROUGH MODES
Short Press the same main button to cycle
between the different modes of LORI.
ON/OFF Button
& Mode Cycling Switch
4
OPERATIONAL MODES:
Once you have assured of the full charge
of the LORI you may proceed with the
treatment of your choice:
MODE 1. = EMS + heat + red indicator
light.
* Hot temperature is about 45°C (±3-
5°C) = 113°F (±37-41°F)
MODE 2. = RF + heat + red indicator
light.
MODE 3. = EMS + cold + blue indicator
light.
* Cold temperature is about 9-15°C
(48-59°F)
MODE 4. = RF + cold + blue indicator
light.
Charging
Smart Sonic
Facial Wand
To Next Page
Loading...
