ELECTRICAL FITTING
INSTRUCTIONS
Unpack all parts and check components against kit list’. Remove the bottle from it’s
plinth by undoing the over-centre clips.
Decide the best position for the extinguisher – IT IS RECOMMENDED THAT THE
BOTTLE SHOULD BE MOUNTED IN THE FORE AND AFT DIRECTION IN THE
VEHICLE.
The extinguisher label, detailing contents, etc and also the pressure gauge should be
visible. Mount the plinth securely to the vehicle and put the bottle back into place.
Mount the power pack in a clearly visible position.
Switch with red plastic shroud to be fitted in the cockpit so that it is in easy reach of both
the driver and/or co-driver when sitting in the normal driving position and wearing fully
fastened seatbelts.
The second switch with flexible red membrane (waterproof) is to be fitted to the outside
of the vehicle, close to the exterior master switch (for activation by the Marshals).
Once the system has been wired as per wiring diagrams (refer to Figure 4), the following
tests should be carried out to check the system is fitted correctly and will operate when
required. (See Page 5)
Page 4
To Next Page
Loading...