4
15. The casualty can now be lowered as follows.
16. To lower the casualty the rescuer must take hold of the
rope that exits the GRIGRI, and this is used to control the
descent.
17. With the other hand releases the black handle on the
GRIGRI until the rope can be fed at a controllable speed. This
thus lowers the casualty.(Please see note)
NOTE: In order to carry out a rescue the rescuer
requires a harness with a front point of attachment for
locating the GRIGRI.
If the anchor point for the GOTCHA™ is such that the
casualty must be lowered, then the rope length in the
kit must be four times the distance from the anchorage
to the point of safety.
Keep these instructions, or a copy with the GOTCHA™ to aid
future inspection, and examination.
The equipment must be given a visual and tactile inspection
when delivered to site/works, and before every use.
SpanSet recommends recorded inspection by a competent
person every 6 months.
Particular attention should be paid to the following:-
Metal-ware – Inspect for signs of damage/distortion/
corrosion, and correct operation & locking of connectors.
Rope* – Examine for any signs of wear/ abrasion, including
interstrand wear, unravelling, extension and fusion.
* Local abrasion as distinct from general wear may be
caused by the passage of the rope over sharp edges or
protrusions whileunder tension and may cause serious loss
of strength. Slight damage to outer fi bres and occasional
yarn may be consideredharmless but any reduction in
diameter of the rope or serious distortion to the sheath
pattern should lead to rejection.
All Personal Protective Equipment should be immediately
removed from service after being subjected to any shock, or
there isany doubt about its condition. (See list above)
The GOTCHA™ may be cleaned if required. The following
procedure mustbe adhered to. Use a mild detergent with
hand hot water, using a cloth, or sponge to wipe the
GOTCHA™ and avoid over wetting. This procedure should
then be repeated withclean water to rinse, then allow to dry
naturally away from any direct heat source. If you require
more information pleasecontact SpanSet.
All equipment should be stored and transported in the
following manner:
• To prevent contact with sharp objects.
• Away from harmful substances.
• In a cool dry place free from direct sunlight.
Gotcha Remote
Rescue kit
5
7
8
To Next Page
Loading...