Chip Antenna U.FL
Qwiic and I C
There are two pins labeled SDA and SCL which indicates the I C data lines. Similarly, you can use either of the
Qwiic connectors to provide power and utilize I C. The Qwiic ecosystem is made for fast prototyping by removing
the need for soldering. All you need to do is plug a Qwiic cable into the Qwiic connector and voila!
The only I C address for this and all u-Blox GPS products is 0x42, though each can have their address
changed through software.
SPI
There are four pins on the right most header that are labeled with their corresponding SPI functionality. As
mentioned in the jumpers section, you'll need to close the SPI jumper on the underside to enable SPI.
2
2
2
2
To Next Page
Loading...