Only after starting the surfing pump can start the heating function effectively by pressing
heating key( ) more than 2 seconds . The heating sign( ) will appear on the screen
accordingly.If the sign is dynamic,it means that the working conditions of heater are satisf ied
and the system is under heating.If the sign is static,it means that the working conditions are not
met and the heater will stop working.[Note:When surf ing pump is switched off,this funcion will
also be deactived.]
Firstly,fill water into the bathtub When the indicating sign( ) goes out, it has reached
standard level,You can press surfing key( ) on the panel for starting of surfing pump while a
dynamic sufng sign will also appear on the screen accordingly.You can switch off the surfing
function by pressing surfing key( ) on the panel.Then the surfing pump will stop running and
the surfing sign on the screen will disappear[Note:A.When the water in the bathtub Does not
reach standard level,the surf ing pump will not start;only static sign( )and f lashing water
shortage sign( )appear on the screen .Then you need to f ill water into the bathtub.B.When
the surfing pump is activated for 60 minutes,it will switch off the function automatically.]
2.Surf ing function:
3.Function of heater(SELECTABLE):
4.Bubble bath pump Function:Press( )key,the bubble bathr pump is turned on,LCD
display “ ” sketch,press again( ) key to turn OFF.
5.Water light function:Press ( )key,the water light is turned on, LCD display
“ ” sketch,press again( ) key to turn OFF.
6.Ozone function:Press( )key for over 2 seconds,the ozone is turned on,LCD display“ O3
” sketch,press again( ) key for over 2 seconds to OFF.(NOTICE:The working-time of the
Ozonizer is 15 minutes. So the Ozonizer auto is turned off after 15 minutes)
To Next Page
Loading...