Remove LL4’s
rear guard and
unplug the
hoses
Place either jet
pack (they are
interchangeable)
into
RL3’s left
shoulder hole
Remove ankle
shields, knee
shield and
connector for
each leg
The inner
ankle
shields are
to be
pegged to
the opposite
hip hole. Lift
torso armor
to enable
you to
connect the
to shields
together
The shields connect together under
the armor. The shields also peg
together in the back
Move outer ankle shields up to
thighs, then plug rear guard tabs
and pegs into shield slots and
holes
9
10
5
6
7
STEPS FOR ASSEMBLING INTERLINK 6
Connect RL3 legs
together by two pegs
Swing cover from side of foot to
front and peg into hole
Remove
jet packs
from back
Remove
both arms.
4
3
2
1
8
NOTE:
Removed
parts may
be used at
different
stages of
assembly.
ASSEMBLY
INSTRUCTIONS PAGE 1
To Next Page
General