1. On:
a. Remove earbuds from EC149 case, or
b. Press & hold the multi-function buttons of Left & Right earbuds (see #5 & #7 on Product
Map above) to turn power ON. EC149 will automatically pair between Left & Right earbuds
(allow up to 30 seconds for Left & Right earbuds to auto-pair during initial use). A short
melody from earbuds indicate the EC149 has been successfully paired.
Once EC149 TWS earbuds are paired to each other, it is automatically in WIRELESS mode.
NOTE: previously paired devices will automatically connect to the EC149
2. Off:
a. Place both earbuds in the charging receptors slot of EC149 case, or
b. Press & hold the multi-function button on one of the TWS earbud & both earbuds will power
OFF. Both earbuds will automatically power OFF after 3 minutes of idle time.
EC149 Wireless Earbud Pairing
a) Stereo Mode:
1. Remove both
earbuds from the charging case
2. The EC149 earbuds will automatically power ON. If blue & red flashing LED do not appear on the
earbuds, press & hold the multi-function buttons on both Left & Right earbuds (see #5 & #8 on
Product Map above) to power ON. Primary earbud will flash red & blue LED quickly while
Secondary earbud will flash blue LED intermittently. (NOTE: allow up to 30 seconds for Left &
Right earbuds to auto-pair during initial
use).
3. Enable Bluetooth function on your electronic device. Search for SPECTOR EC149 & pair the
devices (slow flashing blue LED on each earbud indicates that the EC149 has been successfully
paired to your audio device)
4. To DISCONNECT both earbuds from wireless pairing, press & hold multi-function button on one of
the earbuds until LED is power OFF.
b) Mono Mode:
1. Remove one
earbud from the charging case
2. The EC149 earbud will automatically power ON. If blue & red LED do not appear on the earbud,
press & hold the multi-function buttons on Left or
Right earbud (see #5 or #7 on Product Map above)
to power ON.
3. Enable Bluetooth function on your electronic device. Search for SPECTOR EC149 & pair the
devices (flashing blue LED on the earbud indicates that the EC149 has been successfully paired to
your audio device)
4. To DISCONNECT from wireless pairing, press & hold multi-function button on the earbud until LED
is power OFF.
NOTE: repeat step 1-3 to pair the other EC149 earbud with a different audio device.
Wireless Mode
1. Play/Pause & Answer/End incoming calls: Gently tap ONCE on either one of the multi-function
button of TWS earbuds (NOTE: the EC149 multi-function buttons have an integrated touch sensor
feature, where gentle tapping is required only)
2. Reject incoming calls: Gently tap & hold one of the multi-function button of EC149 earbuds.
3. Redial last incoming caller: Gently tap twice quickly on either one of the multi-function buttons of
EC149 earbuds
4. Skip songs: gently tap & hold either or of the multi-function buttons of EC149 earbuds for 5 seconds
5. Volume control/previous songs must be controlled directly on your audio device
NOTES:
- Although each earbud has a built-in microphone, only the microphone on Primary earbud will be
used in Stereo mode
- Music will automatically stop playing when the EC149 earbuds are placed in the wireless charging
receiver. When both earbuds are removed from the EC149 wireless charging receiver, press play
on your electronic device to resume playing music.
To Next Page
Loading...
General