Spectra Precision FOCUS 35 - Page 117

Chapter 4
Troubleshooting
P/N 79000035_SM, Version 1.5 4 - 31 Focus 30/35 Service Manual
Sensor specific messages Subsystem: FI_Darwin_Tilt
Performance
Sensor specific messages Subsystem: FI_DARWIN_Drives
General status combined from communication status 1 - 6 and sensor specific messages A - D:
Unknown
Ok
Not communicating...
Not initialized...
Not active...
Timeout warning
Failed warning
Turn failed warning
Turn event error warning
Turns blocked
Turns failed
Value Value description Status Ok Counter Error Counter
A
Meas events Ok 635
Counter of
succesful tilt
readings.
0- Ok status
1- Error message
B Meas event timeout Ok - 1- Error message
Additional results
perfoming a
Diagnostics:
A1 Could NOT read 100
tilt readings.
Item System Monitor messages
and message codes stored in
*.fsmx file
Error Log stored in
*.irep file
Recommendation
1 Subsystem error Tilt
Tilt sensor not
communicating 1 2 3 4 A A1
Drive system not enough
turns D1 oder Turn command
failed 6A A1 B D D1 C
FI: 10 Code: 0x9c52
Message: Req x6e got res 9
FI: 10 Code: 0xf005
Message: 1|99|99|21605038|-
5046|PositionHV faile
FI: 1 Code: 0x9c4e Message:
Tilt sensor: Not
communicating, FI 35 0x9c4f
Tilt retry ini.
Check the cable
Exchange the Tilt sensor