Entering Grade – changing the grade value in Step + Go or Digit Select mode.
Press and release the M (Menu) button; Grade Edit will be highlighted.
Press/release button E The grade value will be shown.
Press/release button M escape/return to the standard display.
Note: when ‘Step + Go Mode’ is selected, the grade can be changed just by pressing the plus
[17] and minus [18] arrow. One arrow button press opens the grade edit menu. To change
grade see chapter ‘Step + Go Mode’
Step + Go Mode:
Press and hold (+/-) buttons for changing the grade value after the comma.
Press/release button 2/5 change the sign of the grade value.
Press and hold Plus (+) and Minus (-) buttons simultaneously starts Quick change mode
where the grade value will be set to 0% and then starts changing in front of the comma in 1%
increments.
Note: When the grade value for the axis reaches its highest amount, the grade value switches
to the lowest value for that axis. For example, the value switches from +40% to -12%.
The laser will self-level to the required grade position a few seconds after the grade change
buttons have been released.
Note: The bubble symbol at the laser’s and remote’s LCD will flash until the laser has been
self-leveled to the requested grade position.
Digit Select Mode (Default):
A cursor at the sign of the grade value is flashing.
Press and hold the ESC button quick set to 0%.
Press/release Plus (+) and Minus (-) buttons change the sign of the grade value.
Pressing and releasing right or left button moves the cursor to the right/left.
Press and release Plus (+) and Minus (-) buttons to change the selected digit.
The laser will self-level to the required grade position after confirming the grade change with E
(Enter) button.
Grade Entering can be exited any time by pressing and releasing M button.
21
To Next Page
Loading...
