Single Axis Slope Mode Y-axis
First Up arrow and then (<1 sec.)
the Manual-button
(red + green LEDs flash
simultaneously once a second)
Arrows Up + Down change slope
LL400 – Single Axis Slope Mode
Single Axis Slope Mode is only accessible when set up horizontally.
Single Axis Slope Mode can also be performed using the optional remote control RC601.
Single Axis Slope Mode X-axis
First Right arrow and then (<1 sec.)
the Manual-button
(red + green LEDs flash
simultaneously every 3 seconds)
Arrows Right + Left change slope
Manual-Button
Short press to resume
automatic self-leveling mode
Trimble Construction Tools Division
8261 State Route 235
Dayton, Ohio 45424-6383
U.S.A.
+1 937 245 5600 Phone
IEC/EN 60825-1: 2001,
max. 3.0 mW, t < 0.25 sec, 630 –680 nm
LASER LIGHT DO NOT STARE INTO BEAM
CLASS 2 LASER PRODUCT
CDRH 21 CFR 1040.10 AND 1040.11
To Previous Page
Loading...