10
Operation
14. USER OPTION MODE
a. This allows the user to choose various
operation methods.
b. Open the oven door and press “2” for
5 seconds. The buzzer sounds once to
indicate User Option Mode is activated.
c. The LED will display “OP: --“.
d. Press any number key to enter related
mode setting. Please refer to the chart
below for options.
1. Example: to set the buzzer of key
beep volume to “Medium,” press
“2”. “OP:22” will display on the LED.
2. To change, continue pressing “2”.
The LED will cycle “OP:20”, “OP:21”,
"OP:22”, “OP:23”, etc.
3. Press [START] to save the current
setting. After the setting has been
saved, “OP: --“ will display again.
4. During the programming process,
press [STOP] to enter Door Open
Mode. Closing the door will have
the oven enter Ready Mode.
5. If [START] is not pressed as the last step,
the program will not be saved.
15. INQUIRY FUNCTION
a. During the cooking process, press
[TIME ENTRY] to check the power
level. The LED will display the power
for 3 seconds and then turn back to the
previous state.
NUMBER KEYS DISPLAY OPTIONS Factory Settings Bold
1
END OF CYCLE
BEEP
OP:10 3 second beep.
OP:11 Continuous beep until door is opened.
OP:12 5 beep bursts until door is opened.
2
KEY BEEP
VOLUME
OP:20 Eliminates beep.
OP:21 Sets volume to low.
OP:22 Sets volume to medium.
OP:23 Sets volume to high.
3
KEY BEEP
OP:30 Prevents beep when Number Key is pressed.
OP:31 Allows beep when Number Key is pressed.
4
ACTIVE
DISPLAY
OP:40 15 seconds after oven door is opened, keyboard is disabled.
OP:41 30 seconds after oven door is opened, keyboard is disabled.
OP:42 1 minute after oven door is opened,
keyboard is disabled.
OP:43 2 minutes after oven door is opened, keyboard is disabled.
5
ONTHEFLY
COOKING
OP:50 Prevents dierent pre-programmed Number Key to be
activated during cooking.
OP:51 Allows dierent pre-programmed Number Key to be
activated during cooking.
6
RESET TO
READY MODE
OP:60 Opening oven door does not reset oven back to
ready mode.
OP:61 Opening oven door resets oven back to ready mode.
7
MAXIMUM
HEATING TIME
OP:70 Allows 60 minutes of heating time (some models).
OP:71 Allows 10 minutes of heating time.
8
MANUAL
OPERATION
OP:80 Allows use of preprogrammed Number Key only.
OP:81 Allows use of manual time entry and
preprogrammed Number Key.
9
DOUBLE DIGIT
OPERATION
OP:90 Allows 10 (0-9) preprogrammed Number Keys.
OP:91 Allows 100 (00-99) preprogramed Number Keys.