6
Step 3 :
Connect the power cord of each light bar.
lnstall the dimmer box and driver on the light board.
(lf you don't need to fix the driver on the light, you could directly plug and use.)
Step 4 :
Install the driver bracket:
SE3000: If you need to fix the driver on the light, please take 4 bracket legs(accessory:J1) and
adjust the scales of the 4 bracket legs according to the spacing of the light bars, slide the bracket
legs into the desired place, tighten up the 4 white screws(accessory:H) underneath the driver
bracket to fix the bracket legs, mount the driver on the light.
SE5000, SE7000, SE1000W SF G1000W: If you need to fix the driver on the light, please adjust the
scales of the 4 bracket legs(accessory:J2) according to the spacing of the light bars, slide the bracket
legs into the desired place, mount the driver on the light.
Step 5 :
Connect with adjustable rope ratchets. Hang the light above the plants at appropriate height.
Plug the power cord to the socket.
Turn on light switch.
To Next Page
Loading...
