Need help?Do you have a question about the Spirit Flybarless System and is the answer not in the manual?
General| Type | Flybarless System |
|---|---|
| Telemetry | Yes |
| Vibration logging | Yes |
| Governor | Yes |
| Dimensions | 36 x 25 x 14 mm |
| Compatibility | Helicopters |
| Supported protocols | S.Bus, PPM, DSM2, DSMX, Jeti EX Bus |
| Gyro Sensors | 3-axis |
| Input Voltage | 3.5V - 8.4V |
Describes horizontal mounting of the unit with connectors facing upwards.
Describes vertical mounting of the unit parallel to the longitudinal axes.
Details wiring for flybarred helicopters using the heading hold gyro.
Explains capabilities for flybarless helicopters and servo connections.
Wiring instructions for standard receivers using PWM signal.
Wiring guide for Spektrum DSM2/X satellite receivers.
Wiring instructions for Futaba S-BUS receivers.
Wiring guide for PPM receivers.
Wiring instructions for Jeti EX-BUS receivers.
Wiring guide for SRXL/SUMD receivers.
Specifies orientation for signal wires on unit connectors.
Details connecting the Spirit unit to a PC for configuration and driver installation.
Explains connecting the Spirit unit to the computer via USB and powering it.
Provides instructions for installing the Spirit configuration software on various platforms.
Describes how to run the configuration software after installation and initialization.
Explains how to use the software for configuration and troubleshooting connection issues.
Details the Connection tab in the software for checking status and initial setup wizard.
Covers making additional adjustments in the General tab after initial setup.
Explains channel assignment in the software for various functions like Throttle, Aileron, etc.
Explains the Diagnostic tab for checking channel values and transmitter settings.
Outlines the steps for using the Spectrum Analyzer to measure vibrations.
Explains how to identify the source of vibrations using frequency analysis.
Adjusts servo horns for proper alignment and neutral collective pitch.
Explains how to reverse the direction of cyclic servos for correct operation.
Describes how to adjust servo travel limits for accurate movement.
Lists pre-flight checks and controls before taking off.
Provides steps for performing the initial takeoff and checking controls.
To Next Page