Data di emissione: December, 2013 Revisione: 1 Pag. : 49/68
- In order to activate the refrigerating system
and to regulate the product consistency, it is
necessary to use the buttons
+
and
-
on the
control board (fig.8); operating on the
+
button,
the number of lighted LED will increase with the
product consistency; operating on the
-
button,
the number of lighted LED will decrease with the
product consistency (fig.7).
- In order to activate the refrigerating system in
defrost mode it is necessary to press the –
button an keep it pressed until the first and the
last LED of the scale will turn on.
In order to exit from the defrost mode it is
necessary to press the + button an keep it
pressed until the all the Led will be switched off.
NOTE: when all the LED are switched off the
refrigerating system is not working and the
product is not cooled.
NOTE: when the unit is switched off the
electronic board will keep in memory the last
setting, for this reason the unit will restart in
the same operating mode when switched on
again.
- Once the desired product consistency is
reached, to dispense product position a cup
under the tap and lower the lever as shown in
figure 9.
Fig. 7
Fig. 8
Fig. 9
A
To Next Page
Loading...
Need help?
General
