Set the tank on a level surface in an area where it can get wet around the tank.
Locate the bypass valve with the red arrows and the 1” PVC elbows. Install
bypass valve to head of tank hand tight. Now install PVC elbow onto the Inlet
side. Locate the hose bib assembly and connect it to the Inlet side. Connect a
water hose to the opposite end of the hose bib assembly. Put the bypass valve in
the “on” position. Turn the water on slowly to about halfway on and wait until
water comes out of the Outlet side. Disconnect hose and put the bypass valve in
bypass mode, then set tank aside in a safe place for 2 days.
To Next Page
Loading...
