After the FutureSoft media has soaked for 2 days locate the hose bib assembly
again and connect it to the Inlet side of the tank head. Connect a water hose to
the opposite end of the hose bib assembly. Put the bypass valve to the in
service mode. Turn the water on slowly and only halfway on and allow the water
to run for 15-20 minutes. Turn water off and disconnect the water hose. Connect
water hose to Outlet side of the filter head and turn water on slowly to full
strength. Allow water to run for 5 minutes. Disconnect hose and connect to the
Inlet side of the tank head. Turn water on slowly and to halfway on, run for 10
minutes. Disconnect the hose bib assembly.
To Next Page
Loading...
