This is the point where you will need to shut the main water supply off and
adapt your plumbing in and through the system. We recommend you
plumb a shut off valve before the pre-filter housing. Locate the area where
the system is going to be installed. Locate aluminum pre-filter mounting bracket
with hex bolts and washers. Mount the pre-filter bracket to the wall (hex bolts
into wall with washers). Note that the bracket should be screwed into the
studs in the wall as the weight of the pre-filter once soaked in water will
add weight. (approximately 24 pounds) Now connect the pre-filter housing
head to the mounting bracket with the hex bolts provided. Plumb the water from
the main water supply into the Inlet side of the pre-filter head. Install lubed o-ring
in groove on top of the blue pre-filter housing. Locate pre-filter and install it onto
small pipe stand inside the housing. Screw the housing to the head as tight as
you can without the pre-filter housing wrench. Now take the wrench and tighten
down hand tight
To Next Page
Loading...
