Plumb the main water supply coming out of the pre-filter housing into the Inlet
side of the bypass valve. Now finish the plumbing by connecting the Outlet side
of the bypass valve to the main plumbing supply. Place the bypass valve in
bypass.
Complete Install:
Once the plumbing is complete its time to start the system up. Double check all
connections. The valve nuts should only be hand tight. Slowly turn the main
water supply back on. Check for leaks. If there are no leaks slowly turn the
bypass valve to the on position. Go to a faucet inside and slowly turn the cold
water on about halfway and let it run for about 5 minutes. Turn off the faucet and
you have now completed the install.
Now you can enjoy your new Whole House Salt Free Softener!
To Next Page
Loading...
