1. Disconnect all power on your
network, including your cable
or DSL modem and router.
2.
Plug one end of the yellow Ethernet cable into your
broadband modem.
3. Connect the other end of the cable into the
yellow WAN port at the back of the AIRAVE.
4. Reconnect power to your cable or DSL
modem and wait about two minutes
for the modem to power up and
initialize.
5. Plug the power supply
connector into the
back of the AIRAVE.
6. Plug the other end of
the power cord into an
available electrical outlet.
READ ME FIRST! Setup Instructions
Check that all these components are in the box:
AIRAVE 2.5+
Printed Materials
Power Cord
Yellow Ethernet Cable
External GPS Antenna Cable
Before You Install Your AIRAVE
Install Your AIRAVE
Note: You will also need a working electrical outlet and a
broadband connection (cable, DSL, etc.) to use this device.
continued on
other side
2
3
5
6
1
4
The AIRAVE 2.5+ you requested is enclosed. The
AIRAVE
provides a boosted signal for your wireless voice and
3G
data services. It’s like having your very own cell tower.
1.
Follow the diagram below to connect the antenna
to the AIRAVE.
2.
Place the GPS antenna on a flat surface and next to a
closed window, if possible.
Note: It may take up to 30 minutes for the GPS LED light to
become solid green.
Note: In large homes, the external GPS antenna can be used
to allow the AIRAVE to be placed
in a more central location,
allowing for more even coverage
throughout the house.
Connect the External GPS Antenna
AIRAVE Technical Support: 1-866-556-7310
LAN 2
Reset
LAN 1
WAN
12VDC
GPS
Mobile
Network
GPS
Broadband
Place on Window Sill
AIRAVE
GPS Antenna Module
To Next Page
Need help?
General
