Level surface away from light and heat.
A C
B
Pro Wash/Dry™
Quick Start Guide
Congratulations!
Your new Pro Wash/Dry system is the most technologically
advanced system for cleaning 3D printed parts. Thanks to
its patented mechanical jetting system and onboard
computer, you’ll be saving time, money, and resources.
But before you get started, please read through this guide
and make sure to follow all procedures outlined herein when
using Pro Wash/Dry.
Training and Support
Your Pro Wash/Dry comes with complimentary phone and
email support. If you have questions, please get in touch:
Version 3.3
Updated on 05/20/21
Visit
Call
Email
support.sprintray.com
800-914-8004
support@sprintray.com
Pro Wash/Dry Unit
Drain Hose
Pre-installed
(See Section 7)
Cleaning
Brush
(See Section 8)
Basket
Pre-installed
(See Section 6)
Hydrometers
Pre-installed
(See Section 4)
Power CableUSB Cable
(See Section 12)
Wash Filter
(See Section 9)
Metal
Tweezers
(See Section 9)
Power Adaptor
Magnet Sticker
For Platform
(See Section 10)
Pro 55
Adaptor
(See Section 11)
Onboarding
Card
In the Box
Place your Pro Wash/Dry in a well-ventilated
area on a flat, level surface. Keep it away from
extreme temperatures, windows, bright light
sources, and direct sunlight.
Never set anything on top of Pro Wash/Dry.
Pro Wash/Dry comes out of the
box with most parts pre-installed.
The hydrometers are pre-calibrated
for each chamber to float when it’s
time to refresh solvent.
Where to Set Up
Hello!
1
2
To Next Page
General