7
Time Lapse
The camera can be triggered by timer at a
preset time interval. Please note that even
in Time Lapse mode, the camera still can
be triggered unless the Sensitivity is set to
OFF.
Start-Stop
1/2
The camera can be set to operate only at
specific time period. To enable this function
select ON and press ok. The start-stop
menu will then appear. This menu contains
the settings for times to start and stop as
well as the trigger interval and time lapse
interval. The start-stop setting will override
all other general camera settings. Since
there are 2 periods available, make sure to
not program times that overlap.
SYS
Set Clock Enter to set the Date and Time.
Time Stamp
ON /Off. Choose if the image stamp is to be
shown or not.
Flash Power High / Low. Infrared Flash Power:
Format
Format the SD card. This will erase all data
on the SD card. This cannot be undone.
Default
Restore all settings to factory default
values.
Information
Show Module Number, HW Version, FW
version and IMEI of the camera.
To Next Page
Loading...
