SPX Reformer - Replacing the Carriage - Final Steps; Securing Carriage Components; Reassembling Reformer

17
5. Slide rollers into c-channels.
NOTE: To prevent damaging rollers, it isstrongly advised two
people hold carriage. One person guides rollers carefully into
channels while the other supports opposite side of carriage.
Oncerollers are secured in channels, guide carriage into place.
7. Insert pulleybars into receptacles at rear of Reformer and fully
tighen star knobs so pulleybars are secure. Ensure eyehooks on
top of pulleybars are parallel to aluminum rails.
8. Replace gearbar and engage springs before resuming use
ofthe Reformer.
6. Using a Phillips screwdriver, replace stopper plates.