Need help?Do you have a question about the SPX SPIDAR NIC-500s and is the answer not in the manual?
General| Velocity Accuracy | 0.1 m/s |
|---|---|
| Cold Start | 45 s |
| Warm Start | 35 s |
| Acquisition Sensitivity | -148 dBm |
| Operating Temperature | -40°C to +85°C |
| Interface | UART |
| Receiver Type | GPS L1 C/A code |
| Update Rate | 1Hz |
| Position Accuracy | 2.5m CEP |
| Input Voltage | 5 V DC |
Details the NIC-500N variant for Noggin systems.
Details the NIC-500P variant for pulseEKKO PRO antennas.
Details the NIC-500X variant for pulseEKKO PRO antennas.
Guides on connecting components for a single NIC-500 unit.
Instructions for daisy-chaining multiple NIC-500 units.
Explains how to connect and use an optional GPS receiver.
Steps for powering on the NIC-500 system.
How to connect a computer or tablet to the NIC-500.
Procedures for safely shutting down the NIC-500.
Overview of the SPIDAR software welcome screen and navigation.
Managing data acquisition projects within the SPIDAR software.
Configuring system parameters, antennas, GPS, and triggers.
Using Scope mode to verify connections and signal timing.
Performing line scan data acquisition and viewing settings.
Managing software updates, network settings, date/time, and logs.
Steps to activate the SPIDAR Software Development Kit mode.
Setting up the computer's Ethernet connection for SDK.
Understanding system behavior and limitations in SDK mode.
Methods for communicating with the NIC-500 using HTTP requests.
Troubleshooting common issues when using SDK.
Attaching couplers to extend SmartCart capacity.
Mounting NIC-500 units onto fiberglass tubes.
Using hardware to stack NIC-500 units.
Using an extension cable for odometer connections.
Estimating power needs for system components.
Opening and utilizing exported .GPZ files in EKKO_Project.
Compatibility requirements for Noggin sensors.
Compatibility requirements for pulseEKKO systems.
Mode for simultaneous transmitter firing, default for NIC-500N/P.
Mode for multiple receivers collecting from one transmitter.
Advanced mode for dynamic transmitter-receiver pairing in NIC-500X.
Details and pinout for the Odometer input port.
Specifications for the Link In port for triggers and power.
Compliance and operating regulations per FCC rules.
Compliance requirements for the European Community.
Compliance requirements per Industry Canada (English).
Compliance requirements per Industry Canada (French).
To Next Page