Document No. 500 045-001
December, 1992
Installing PCWS Software
________________________________
© 1991 Square D All Rights Reserved
__________________________
Page 9
General This section explains the PC Workstation Software installation procedure.
Additional information is provided for configuring the PC Workstation.
Installation Perform the following steps to install PC Workstation software.
Procedure
Step 1. Insert PC Workstation Diskette
Insert the PC Workstation diskette in an appropriate drive.
Step 2. Change the Default Drive
At the DOS prompt, change your default drive to that which contains the
PCWS distribution disk. For example, refer to the following.
A:<ret>
Step 3. Install PC Workstation Software
Enter the install command.
A:> INSTALL<ret>
Several prompts will be issued, requesting system configuration information.
Enter the appropriate responses based on the system configuration.
To Next Page
Loading...