Document No. 500 045-001
December, 1992
Introduction
________________________________
© 1991 Square D All Rights Reserved
__________________________
Page 1
General This manual provides a step-by-step installation procedure for the PC
Workstation software. This procedure can be used for a new installation or
for updating an existing system.
This manual is broken down into the following sections.
Section Description
Requirements Defines the system requirements before installation of
the PC Workstation software.
(page 3)
Installing DOS Defines the DOS installation procedure.
(page 5)
Installing PCSA Defines the DECnet installation procedure.
(page 7)
Installing PCWS Defines the procedures required to install PCWS
software.
(page 9)
NOTE
Before performing this installation procedure, verify that
the PC workstation hardware has been properly installed
per the appropriate documentation.
PC Workstation software is designed to interface with
MicroVAX or VAX systems running VMS, V5.0 or later, and
CRISP/32, V2.04 and later.
To Next Page
Loading...