SERVICE AND MAINTENANCE
13-20
0
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
Higher amperage
Normal
HOW TO CHECK AND REPLACE FUSE
1. Turn off all electrical systems and remove the ignition key
from the key cylinder.
2. Open the fuse and relay box cover.
3. Locate the defective fuse.
4. Pull out the relevant fuse by using the fuse puller.
5. Visually check whether it is blown or not.
6. If normal, insert it to its original position.
7. If blown, check its capacity and replace it with the same
capacity.
Open
Specified amperage
• The use of anything other than the specified fuse could cause dam-
age to the electrical system and even cause a fire.
• The use of different types or different rating fuses could cause
damage to the electrical system and even cause a fire. Always re-
place a fuse with the one with the same rating.
WARNING
The underhood fuse and relay box has some spare fuses. Refill the
fuses immediately as you use them. The fuse rating is indicated on the
upper surface of the fuse.
NOTE
C100_RHD_13-Service and Maintenance.p65 2006-05-16, ¿ÀÈÄ 8:3120
To Next Page
Loading...
Need help?
General
