5-16
1. Locate the fuel filter ( ) & water separator ( ) in engine
compartment.
2. Place the water container under the fuel filter (
) & water
separator ( ).
3. Disconnect the connector under the drain plug ( ) of the
water separator.
4. Turn two drain plugs to “
” direction to drain the water.
5. Press priming pump until all water is drained. After draining,
turn the drain plug until the gasket contact to the threaded
plug hole, then tighten (“ ” direction) it 1/2 turns by hand.
6. Engage the connector under the drain plug and press the
priming pump ( ) until it becomes rigid.
7. Close the engine hood and start the engine.
Be careful not to be injured by surrounding equipment during the
working procedures.
CAUTION
If the priming pump is not properly operated, air may get into the fuel
line. It may cause starting problem or fuel system problem. Make sure
to perform the job in step 6.
WARNING
1. Fuel filter
2. Priming pump
3. Water separator
4. Drain plug
5. Connector
A. Opening direction of drain plug
B. Closing direction of drain plug
A120_RHD_05-Instrument Panel.p65 2006-10-02, ¿ÀÀü 11:05Page 16 Adobe PageMaker 6.5K/Win
To Next Page
Loading...
Need help?
General
