SSP Professional Lighng
www.sspworld.com
14
4.Master Slider
Master Slider control provides proportion level control over all channels and scenes with the ex-
ception of the Flash Buttons. For example:
Whenever the Master slider control is at minimum all stage outputs will be at zero except for any
resulting from a Flash Button or FULL ON Button.
If the Master is at 50%, all outputs will be at only 50% of the setting of current channel or scenes
except for any resulting from a Flash Button or FULL ON Button.
If the Master is at full all outputs will follow the unit setting.
Master A always controls outputs of channels. Master B controls program or a scene except in
Double Press Mode.
5.Single Mode
1) All programs will run in sequential order starting in the order of program number.
2) The 3 digit LCD display will read the running program number.
3) All programs will be controlled by the same Speed Slider.
4) Press the MODE SEL. Button and select “CHASE SCENES”.
5) Press the PARK Button to select SINGLE CHASE MODE. A red LED will indicate this selection.
6.Mix Mode
1) Will run all programs synchronously.
2) All programs can be controlled by the same SLIDER SPEED, or each programs speed may be
controlled individually. (See Speed Setting).
3) Press the MODE SEL. Button and select “CHASE SCENES”.
4) Press the PARK Button to select MIX CHASE MODE. A yellow LED will indicate this selection.
7.Dimmer Display
1) The 3-Digit LCD display is used to display intensity percentage or absolute DMX value.
2) To change between percentage and absolute value: Press and hold the Shift Button. While
holding down the Shift button press the 5 or 0-255 Button to switch between percentage and abso-
lute values.
3) If the Segment Display reads, for example, “076”, it means a percentage value 76%. If the Seg-
ment Display reads “076”, it means the DMX value 76.
8. Blind and Home
1) Blind function takes channels temporally out from a chase, when the chase is running, and
gives you manual control over the channel.
2) Press and hold the Blind Button and tap the relative Flash Button you want to temporarily take
out of the chase.
3) To return to normal chase again press and hold the Home Button and push the Flash Button
you want to return to normal chase.
To Next Page
Loading...