SSS Siedle BFS 850-02 - 7 Programming - manual; Activating the bus line rectifier

65
7 Programming - manual
Activating the bus line rectier
To activate the programming mode
at the bus line rectier, the pro-
gramming mode button has to be
briey pressed down. LED1 indicates
whether the programming mode
is switched on. After activating the
programming mode, LED1 changes
over from normal mode to program-
ming mode.
Indication at LED1 Function display
LED ashes briey 0.02 secs. – long pause 1 secs.
etc.
Pause
Pause Pause
Using a small screwdriver, set the
bus line rectier to the programming
mode through the opening in the
cover.
Note:
If no programming process takes
place within 10 minutes, the
BNG 650-... switches back to the
standard operating mode.
Indication at LED1 Programming mode active
LED ashes briey 0.3 secs. – long pause 2 secs.
Pause
etc.
Pause