Note: If you would like to change the fragrance, empty Nora completely and
clean the water container with a damp cloth. Fill Nora once again and pour the
drops into the device following the instructions.
Cleaning
Prior to any maintenance and after each use, switch off the appliance (3) and
disconnect the USB cable (1) from it (2).
Careful: Never immerse the device in water (danger of short circuit).
• Daily: Fill the appliance with fresh, cold tap water. If the appliance is not used
for several days, empty the water from the lower part (6) beforehand and if
necessary, clean it with a bit of dish detergent and a clean cloth. Fill fresh
water into the lower part (6) before putting the appliance back into operation.
• Regularly as required: To clean the outside, rub with a damp cloth and then
dry thoroughly.
• If you have hard water (with a high lime content), a white coating will build up
on the inside. This coating consists of very fine limescale particles that you can
wipe off easily with a cloth or microfibre cloth.
• If there are marks caused by water and/or fragrances on the lid (10), clean
it with a damp cloth and a squirt of washing-up liquid. Then dry the lid thor-
oughly before using the appliance again.
• Internal cleaning: You can clean the ultrasonic membrane with a convention-
al household descaler. If there are lime deposits, we recommend that you
use Stadler Form Cleaner & Descaler (www.stadlerform.com/accessories).
To Next Page
Loading...