• Clean the water tank every 3 days
• Empty and clean the diffuser before storage. Clean the diffuser before next use.
• Warning: Micro-organisms that may be present in the water or in the environ-
ment where the appliance is used or stored, can grow in the water tank and be
blown in the air causing very serious health risks.
Setting up / operation
1. Place Zoe in the desired position on a flat surface. Connect the USB cable (1)
to the power adapter (2) and to the appliance (3) and insert the adapter into a
suitable socket. Alternatively, you can also connect the USB cable to another
power source such as a PC or an external battery (battery pack/power bank)
with 2 A.
2. Remove the lid (4) to fill with water and fragrance.
3. Fill the water container (5) up to the maximum mark (MAX) (6) with water. No
water may enter the air outlet opening (10). This will damage the appliance and
will void any claim to the warranty. Important: please do not carry Zoe around
whilst it is filled with water. The water could run into the electronics.
4. Add 2–3 drops of your favourite liquid fragrance directly into the water. It is
not necessary to mix them as the ultrasonic membrane (7) does this for you.If
the fragrance is not intensely enough, you can increase the number of drops.
5. Close the lid (4) again.
6. Then switch Zoe on by pressing the on/off button (8). The LED in the centre
of the top part will then start to glow. If this does not happen, check whether
there is sufficient water in the device or if the adapter is connected to the
electricity supply.
To Next Page
Loading...