To Next PageTo Next Page
Need help?Do you have a question about the Stagnoli ALPHEO 230V and is the answer not in the manual?
Manual is for qualified personnel only; observe standards, use original parts, ensure gate solidity, disconnect power, use proper electrical protection.
Table detailing gate leaf size and maximum weight capacity for different ALPEHO models.
Diagrams showing the physical dimensions of the ALPEHO motor unit.
Procedure to adjust the mechanical stop 1 for the closing phase of the gate.
Procedure to adjust the mechanical stop 2 for the opening phase of the gate.
Verify gate structure, pivot lubrication, and closing limit stops before motor installation.
Fix the bracket plate on the column 100mm from the ground using Ø14 rawlplugs and M8 screws.
Fix the bracket plate on the gate wing using M6 screws, following installation quotes.
Table 1: Installation dimensions for bracket fixing when mechanical stops are not used.
Table 2: Installation dimensions for bracket fixing when mechanical stops are used.
Unscrew the 4.2x9.5 screws and remove the motor cover (Fig. 3).
Fit the geared motor onto the base plate and lock it with M8x90 screws and nuts (Fig. 4).
Align arm by keyed shaft, add washer, and secure with M10x28 screw.
Release motor with key, open gate 90°, and pull release knob.
Fit bushing and lock curved arm to gate bracket with M12x40 screw and M12 nut.
Wiring diagram for swing gate with left leaf delay and control unit on the left-hand motor (ALPHEO 230 (M)).
Wiring diagram for swing gate with left leaf delay and control unit on the right-hand motor (ALPHEO 230 (M)).
Wiring diagram for swing gate with right leaf delay and control unit on the left-hand motor (ALPHEO 230 (M)).
Wiring diagram for swing gate with right leaf delay and control unit on the right-hand motor (ALPHEO 230 (M)).
Procedure to calibrate the lower cam for the opening microswitch trip.
Procedure to calibrate the upper cam for the closing microswitch trip.
Calibrate bottom cam clockwise for closing microswitch trip.
Calibrate top cam counter-clockwise for opening microswitch trip.
Product ALPHEO complies with EMC, LVD, and R&TTE European Directives.
General