OPERATION
3200 SERIES OWNER’S MANUAL
REMOTE CONTROL
The crane remote control plugs into a receptacle. The blue line on the male plug on the remote control must line
up with the flat spot on the receptacle at the base of the crane. Push the male plug onto the receptacle while
turning the serrated portion of the male plug clockwise. Continue turning until the pin on the receptacle can be
seen through the hole in the male plug and a “click” is felt.
There are five switches on the remote control. Each is labeled as to the function and direction. For example: To
activate the winch, push up on the switch to “winch up”; push down on the switch to “winch down”.
7
s
To Next Page
