12
ASSEMBLY INSTRUCTIONS
23. REMOVE ALL PACKING MATERIALS
FROM STEPMILL. ROLL STEPMILL TO
FINAL LOCATION.
24. INSTALL FOUR LEVELING PADS INTO
THREADED HOLES IN THE BOTTOM
SURFACE OF THE STEPMILL. TILT
STEPMILL AND REMOVE THE WHEELS,
AXLES, AND CLIPS. RETAIN THESE ITEMS
FOR FUTURE USE IF THE STEPMILL WILL
BE MOVED TO A NEW LOCATION. PLUG IN
POWER SUPPLY TO RIGHT SIDE OF
STEPMILL AND POWER SOURCE.
POWER SUPPLY
LEVEL PADS
25. SEE OWNER’S MANUAL FOR SET UP
AND OPERATING INSTRUCTIONS.
To Previous Page
Loading...