Stanley 204143 - Wiring the Operator for Required Handing (Magic-Force Operators); Wiring the Power Close Speed Module; Wiring the ON;OFF;HOLD OPEN” Switch and Power Switch; Wiring the Door Activation or Safety Device

iQ Control Box
10 Document # 204143 REV 5 • www.stanleyaccess.com • 1.800.7.ACCESS
Copyright 2019, Stanley Access Technologies, LLC. All rights reserved. Reproduction
in whole or in part without the express written permission of Stanley is prohibited.
10.18.2019
Wiring the Operator for Required Handing (Magic-Force Operators)
NOTE: Operator cams are factory-set for right hand operaon.
• Refer to Figure 4, and DETERMINE door handing.
• CONNECT operator harness from close speed module to control box motor 1 and motor 2 connectors,
if applicable
Wiring the Power Close Speed Module
Refer to Aachment 2 and CONNECT the Power Close Speed Module.
Wiring the “ON/OFF/HOLD OPEN” Switch and Power Switch
• Refer to Aachment 2, and CONNECT ON/OFF/HOLD OPEN switch wiring as follows:
TB2 Terminal Connection Switch Wire Color
1 Hold Open Yellow
2 Common Orange
3 Automac On Violet
• SET POWER switch to OFF.
• CONNECT POWER switch harness 516857-1 to power harness 415000.
• CONNECT line connect harness 412544 to power harness 415000.
Wiring the Door Activation or Safety Device
NOTE: Aachments 2, 3, and 4 illustrate typical wiring for various devices. Though the specic device may not be
shown, this aachment can be used as a general guide. Specic wiring instrucons from the manufacturer must
also be consulted.
Refer to Aachments 2, 3, 4 and applicable manufacturer’s instrucons, and CONNECT door acvaon
or safety device.
LEFT HAND
DOOR
OPENING
MOTION
RIGHT HAND
Figure 4. Door Handing