To Next PageTo Next Page
Need help?Do you have a question about the Stanley 51180 and is the answer not in the manual?
Connect the receiver to a power outlet to begin the setup process.
Press and hold the receiver's power button for 5 seconds to enter pairing mode.
Press the transmitter's 'ON' and 'OFF' buttons to finalize the pairing.
Press and hold the receiver's power button for 5 seconds to start the removal process.
While the LED flashes, press and hold the receiver's power button for another 5 seconds.
Press the receiver's power button once to confirm the reset of paired transmitters.
Mount receiver 6" high, point outlets down, use GFCI outlets for electrical safety.
Control power using the transmitter's ON/OFF buttons for manual operation.
Use the PHOTOCELL setting to automatically turn devices ON/OFF at dusk/dawn.
Press receiver button to override; avoid holding to prevent entering pairing mode.
Details ratings for indoor use: 120VAC/60Hz/5A/600W, battery, etc.
Details ratings for outdoor use: 125VAC/60Hz/8A/1000W, cord, etc.
Reset receiver to remove all paired transmitters; refer to step 1 for re-pairing.
General