19
Instruction Manual
Introduction
F. Breathing Protection
WARNING
DUST AND FUME HAZARD
To Avoid Injury:
• Dust and fumes generated when using assembly power tools for blind rivet fasteners can cause ill health (for example, can-
cer, birth defects, asthma and/or dermatitis); risk assessment and implementation of appropriate controls for these hazards
are essential.
• Risk assessment should include dust created by the use of the rivet setter and the potential for disturbing existing dust.
• Where dust or fumes are created, the priority shall be to control them at the point of emission.
• All integral features or accessories for the collection, extraction or suppression of airborne dust or fumes should be correctly
used and maintained in accordance with the manufacturer’s instructions.
• Use respiratory protection in accordance with employer’s instructions and as required by occupational health and safety
regulations.
• Respirators shall be used where contaminants in the work area present a hazard.
G. Projectile Hazards
WARNING
PROJECTILE HAZARD
To Avoid Injury:
• Failure of the work piece, of accessories, or even of the tool itself may generate high velocity projectiles.
• Always wear impact-resistant eye protection during operation of the rivet setter. The grade of protection required should be
assessed for each use.
• Ensure that the work piece is securely fixed.
• Defeating the push-to-start feature and pulling a rivet, not in a work piece, will cause a projectile hazard.
• Defeating and operating the tool without a cup or vacuum pickup for the Mandrel Collection System (MCS) can cause the
mandrel to become a projectile.
To Next Page
Loading...
