OPERATING THE OVEN MANUALLY
1. Simply turn the oven temperature control until
the temperature desired appears on the LCD
screen. (If oven ON and OFF times are shown,
cancel the oven timer by pressing the Oven
Manual button)
2. When cooking is finished, to turn the oven
OFF, rotate the temperature control fully
anticlockwise
3. Tip: If you use the oven pre-heat, the oven will
attain the set temperature much more quickly!
Simply program pre-heat to come on about
half an hour before you normally would start
cooking.
SETTING THE COOKING PROGRAMME
and “SWITCH OFF” times will appear below
the current time display. (see Fig 3)
2. To set the cook start time, press the “
button and the “COOK START” time will flash.
3. Adjust it to the desired start time using the + or
- buttons.
4. To set cook stop time, press the “
and the “COOK STOP” time will flash.
5. Adjust it to the desired finish time using the +
or - buttons.
6. Set the oven thermostat to the required
temperature.
7. To return to Manual oven cooking, press the
8. If desired, you can leave the oven timer
selected, in which case the oven will come on
to the selected temperature at the same time
every day.
Cook Start
Time
Cook Start
Time Button
Cook Stop
Time Button
Manual
Cook Stop
Time
PROGRAMMING CENTRAL HEATING, HOT
WATER OR OVEN PREHEAT
The heating can be set individually for both Central
Heating, Hot Water, and Oven preheat and each
setting has 3 on/off programmes for each day.
These can be set in three different ways:
A. All 7 Days simultaneously.
B. First Monday-Friday, then Saturday & Sunday
C. Each Day Individually.
1. Press the "F" button and hold it for five seconds
until the red “SET DAY/TIME” light illuminates.
Press the “F” button again and the red light
moves to set Domestic Hot Water. Each
subsequent time it is pressed the mode will
move on to the next position.
2. The display will be as shown in Fig 4, with the
arrow flashing underneath the day you wish to
program for. The time on the bottom left and
bottom right sides are the ON and OFF times
respectively. The number “1” at the bottom of
the display signifies that these are the times for
the first ON/OFF setting of the day/days.
3. The programs can be set for the individual
days, for weekdays, for weekends and for the
entire week. The days you wish to program for
can be changed by moving the flashing arrow
using the + and - buttons. Fig 5 (a) shows the
day setting for setting the same programme for
Monday to Friday, Fig 5 (b) shows it for setting
the same programme for Saturday & Sunday
and Fig 5 (c) shows it for setting the same
programme for the entire week.
Fig3
Fig4
6
1. Press the “
“ button and the “SWITCH ON”
“
“ button
” button.
“
To Next Page
Loading...
