4. After selecting the day, press the “ ” button
and the 1st ON time will flash. This time can be
adjusted in ten minute intervals using the + and
- buttons.
5. Press the “ ” button and the corresponding
OFF time can be adjusted using the + and -
buttons.
Note that you cannot set an OFF time to be
earlier than ON time, or the ON time to be
earlier than the previous OFF time. The
programmer will automatically correct settings
if you do this.
6. The 2nd & 3rd ON/OFF times can be viewed by
pressing the “ ” button and can be set by
repeating Steps 4 & 5
7. Note that if you do not want to use all three
ON/OFF times, simply set the OFF time the
same as the ON time.
8. To exit DHW setting press the “F” button four
times, or press once to edit the Central heating
programs. Press once more to edit the pre-
heat programs in just the same way.
9. To have the appliance operate on the
programmed settings, press the appropriate
button on the right hand side of the control
panel once so that a light can be seen beside
auto.
Fig 5B
Fig 5C
SETTING THE BOILER SET TEMPERATURE
1. Press the "F" button and hold it for five seconds
until the red “SET DAY/TIME” light illuminates.
Press the “F” button repeatedly until the LED
beside “ °C ” is illuminated.
The boiler set temperature will be displayed.
2. The boiler set temperature can be adjusted
between the limits 60 – 80 °C by pressing the
+ and - buttons.
Fig 6
7
Fig 5A
SETTING THE ALARM TIMER
The alarm timer allows cooking to be timed up to a
period of 99 minutes. (it does not turn the oven on or
off) The alarm can be set by following the procedure
below:
1. Press the “alarm” button and a “00 ALARM” will
flash on the display (See Fig 6).
2. Adjust the alarm time to the desired setting
using the + or - buttons.
3. The timer will start immediately when the
setting + or - button is released.
To Next Page
Loading...
