Stanley ST55 - Environmental and Service Information; Product Disposal and Recycling; Authorized Service Network; Vibration and Noise Emissions

11
ENGLISH
(Original instructions)
Min. and max. radius of circular to be cut (distance between the
center of circle and the center of bit) are as follows:
Min.: 65 mm
Max.: 222 mm
NOTE:
u Circles between 173 mm and 186 mm in radius cannot be
cut using this guide.
u Align the center hole in the straight guide with the center
of the circle to be cut. Drive a nail less than 6 mm in
diameter into the center hole to secure the straight guide.
Pivot the tool around the nail in clockwise direction.
Router bits (Optional) (Fig. K)
No. Description Application
1 Straight bit Grooves and rebates
2 Trimming bit Trimming laminates or
hardwood; accurate proling
using a template
3 Rebating bit Rebates on straight or curved
workpieces
4 V-grooving bit Grooves, engraving and
decorative edge moulding
5 Core box bit Fluting, engraving and
decorative edge moulding
6 Core bit Decorative edge moulding
7 Ogee moulding bit Decorative edge moulding
8 Rounding over bit Rounding over edges
9 Dovetail bit Dovetail joints
10 Chamfer bit Chamfer edges
The shank diameter MUST correspond to the collet size
of the tool.
The bits diameter should be up to 26 mm.
Maintenance
Your Stanley tool has been designed to operate over a long
period of time with a minimum of maintenance. continuous
satisfactory operation depends upon proper tool care and
regular cleaning.
Warning! To minimize the danger of serious
personal injury, please switch off the tool power and
disconnect all plugs before adjusting or removing/
installing any accessory. Before reassembling the tool,
press and release the trigger switch to make sure the tool is
already switched off.
Warning! Before performing any maintenance on corded/
cordless power tools:
Lubrication
Stanley tools are properly lubricated at the factory
and are ready for use.
Tools should be lubricated regularly every year depending
on usage. (Tools used on heavy duty jobs and tools
exposed to heat may require more frequent lubrication.)
This lubrication should be attempted only by trained power
tool repairperson’s such as those at Stanley service centers
or in other qualied service personnel.
Cleaning
Warning! Regularly clean the ventilation slots in your tool
using a soft brush or dry cloth.
Warning! Never use solvents or harsh chemicals to clean
non-metal parts of the tool. These chemicals may weaken the
material of the parts. Use only mild soap and damp cloth to
clean the tool. Never let any liquid get inside the tool; never
immerse any part of the tool into liquid.
IMPORTANT! To ensure product SAFETY and
RELIABILITY, repairs, maintenance and adjustment
(other than those listed in this manual) should be
performed by authorized service centers or other
qualied organizations, always using identical
replacement parts. Unit contains no user service
able parts inside.
Optional Accessories
Warning! Since accessories, other than those
offered by Stanley, have not been tested with this
product, use of such accessories with this tool could be
hazardous. To reduce the risk of injury, only Stanley,
recommended accessories should be used with this product.
The performance of any power tool is dependent upon the
accessory used. Stanley accessories are engineered to
high quality standards and are designed to enhance the
performance of power tool. By using Stanley accessories
will ensure that you get the very best from your Stanley tool.
Stanley offers a large selection of accessories available at
our local dealer or authorized service center at extra cost.
Protecting the environment
Z
Separate collection. Products and batteries
marked with this symbol must not be disposed of
with normal household waste.
Products and batteries contain materials that can be recov-
ered or recycled, reducing demand for raw materials.
Please recycle electrical products and batteries according to
local provisions. Further information is available at www.2hel-
pU.com