Need help?Do you have a question about the Stanley STHT77588 and is the answer not in the manual?
General| Model | STHT77588 |
|---|---|
| Category | Stud Sensor |
| Display Type | LCD |
| Power Source | 9V battery |
| Auto Calibration | Yes |
| Low Battery Indicator | Yes |
| Detection Depth for AC Wire | 2 inches (51 mm) |
| Detection Modes | StudScan, DeepScan, MetalScan |
Explains the tool uses electronic signals to locate studs and wires.
Defines severity levels for signal words (Warning, Caution, Notice).
Step-by-step guide to insert new AAA batteries into the stud sensor.
How to use the stud sensor to find wood/metal studs and AC voltage.
Step-by-step guide to locate studs using the sensor.
Guide to detect live AC wires using the stud sensor.
Instructions for cleaning, care, and storage of the stud sensor.
Addresses the issue of the LED indicator blinking and its causes.
Troubleshooting steps when the LED indicator fails to turn on.
Solutions for when the stud sensor fails to detect studs.
Information on authorized service and repair procedures for the product.
Details on the product's one-year limited warranty and replacement policy.
Detailed technical specifications for STHT77587 and STHT77588 models.
To Next Page
