READ ALL INSTRUCTIONS
Safety
• These instructions are for your safety. Please read through them thoroughly prior to installation
and retain them for future reference.
• Always organise cables and extension leads so that they will not be a trip hazard.
If the external flexible cable or cord of this luminaire is damaged, it must only be replaced by
a qualified electrician to avoid any electrical hazards.
•
• Check the pack and make sure you have all of the parts listed.
• Remove all packaging, wrap etc. from the product.
• Decide on the appropriate location for your product.
• IP65 product: Totally protected against dust. Protected against low pressure jets of water
from all directions. Limited ingress permitted.
• Always refer to the installation drawing for the orientation of the product.
• Never put anything on the product or hang anything on any part of this product.
• When the product does not light after installation:
> Ensure there is no electricity failure
> Ensure all the connections are secured
• Always disconnect the product from mains at least 10 minutes allowing to cool down before
any maintenance or adjustment.
• CAUTION: Do not stare at the operating LED light source.
Cleaning care
• The lamp can be cleaned with a clean dry cloth. Do not immerse it in water.
• Always switch off the supply before cleaning.
Parts Supplied
x1
Installation Instructions
Images for illustration purposes only – Product may differ slightly from the one shown
plug-in
Unfold the stand
Multi-direction rotating can meet more requirements.
Side and bottom knobs for easy light head and stand
adjustment.
210°
90°
To Previous Page
Loading...
Need help?
General
