CHARACTER SET COMMANDS
Select standard character set
Mode ASCII
Decimal
Hexadecimal
< ESC > “t” “0” 27 116 48 1B 74 30
Both
< ESC > “t” co> 27 116 0 1B 74 00
< F!j > “I” co> 28 73 48 1c 49 30
Std.
< FS > “I” co> 28 73 0 1c 49 00
Selects the standard character set. This is the power-up default in Standard
mode if DIP switch 1-7 is ON.
Select IBM character set
Selects an IBM character set. This is the power-up default in IBM mode
if DIP switch l-7 is OFF.
Select character set #7
Mode
ASCII
Both <ESC> “7”
Selects character set #I.
Select character set #2
Decimal Hexadecimal
27 5.5 1B 37
Mode ASCII
Decimal Hexadecimal
Both 1 <ESC> “6” 1 27 54 IlB 36
Selects character set #2.
Select international character set
Mode ASCII
Decimal Hexadecimal
Std. <ESC>
“R” n 27 82 n 1B 52 n
IBM
<FS> “R” n 28 82 II 1c 52 n
Selects an international character set according to the value of n as shown
next.
61
To Next Page
Loading...
